The p07 error code in canon pixma mp280 printers, also known as the full waste ink pads one, means the printer has already done all the prints it could with the set of waste ink pads installed inside it. This error message is more common among printers with continuous ink systems, since these kinds of printers demands more ink absorbers for their own efficiency needs.
What canon is trying to do with this error is keeping the printer’s residues from reaching the motherboard and causing damage. Getting it wet with ink can produce short circuits and many more electrical mishaps, just as it would on any other piece of hardware. This will stop you from printing until you take the printer to a proper maintenance center.
Now we will show you how to restore your canon pixma mp280 printer to get rid of this error message. This post also includes a download link to a restore software.
Once you’re in service mode, your printer will move a bit and then show the number 1 on its main screen.
Buy this program via Paypal for just $3.00...
Here’s the download link where you can get the service tool program for your canon pixma mp280 printers.
In this step, you will need to open the zipped file. You can extract it if you want, but you don’t have to do it, and you can still work with the zipped or compressed file as we did in this post. Please take a look at the last image.
En la pantalla siguiente nos aparecerán una serie de opciones en la cual debemos dar click en "SET" de la parte "Clear Ink Counter".
Finally, turn your printer off and on again. The on/off button on your printer will blink after you press the set key; this means everything’s set. If you want, you can do this twice, but it’s not mandatory.
If this tutorial doesn’t work out for you, please contact us by leaving a comment in the section below this post, and we will gladly help you out.
This post’s content was last updated on 02/14/2013. The download link has been replaced and some information about the restoring process and the blinking on/off lights has been added. Created by +José Altagracia Paredes
What canon is trying to do with this error is keeping the printer’s residues from reaching the motherboard and causing damage. Getting it wet with ink can produce short circuits and many more electrical mishaps, just as it would on any other piece of hardware. This will stop you from printing until you take the printer to a proper maintenance center.
Now we will show you how to restore your canon pixma mp280 printer to get rid of this error message. This post also includes a download link to a restore software.
Before you do anything else:
Turn off every printer attached to the computer, including this one. After turning it off, please disconnect both the USb and power cables from it. Then, press and hold the stop/reset button, and while it’s pushed down, press the on/off button again. After this, you must press the stop/reset button five times in a row to access your printer’s service mode.Once you’re in service mode, your printer will move a bit and then show the number 1 on its main screen.
Buy this program via Paypal for just $3.00...
Here’s the download link where you can get the service tool program for your canon pixma mp280 printers.
 |
| unzip the downloaded program |
 |
| unzip the downloaded program complete |
 |
| as running the software correctly |
If this tutorial doesn’t work out for you, please contact us by leaving a comment in the section below this post, and we will gladly help you out.
This post’s content was last updated on 02/14/2013. The download link has been replaced and some information about the restoring process and the blinking on/off lights has been added. Created by +José Altagracia Paredes
No hay comentarios:
Publicar un comentario